Knowledge
Choose the guide for the task in front of you: prepare a feasibility trial, configure a smart camera, connect a GigE camera or build a PC-based inspection. Each link states the software or hardware scope and the result to work towards.
For supported SC-series smart cameras in SCMVS. Follow connection, network, trigger and inspection configuration. Check the model-specific wiring notes, especially the distinction between SC2000 and SC2000E.
For a first SC1000/SC2000 commissioning session. Progress from connection and a usable image to one validated inspection, a fresh PLC result and a restart test.
For the project team before a feasibility trial. Collect samples, defect limits, cycle time, environment and interface requirements. Use the checklist to agree evidence and acceptance criteria before ordering a system.
For industrial GigE cameras configured in Hikrobot MVS. Work through power and IP settings to a saved image, with symptom-based checks if discovery or acquisition fails.
For a PC-based inspection in Hikrobot VisionMaster. Follow the version-labelled examples for Image Source, Fast Match and Blob Analysis, then challenge the decision with independent images.
Calculate the transmitted payload from image size, pixel format and frame rate. Use the worked examples to check a link budget before selecting a network connection.
Compare separate network ports with a shared switch. Check addressing, Power over Ethernet and simultaneous capture against the available transfer capacity.
Estimate processing, memory, storage and power requirements. Use the acceptance worksheet to benchmark the complete inspection rather than selecting a PC from processor name alone.
Collect hardware details, labelled product samples and PLC decisions before commissioning. Includes a readiness table and the evidence to retain when a setup stage fails.